22
25.0Fitting the Fascia Panels:
To avoid scratches or knocks to the fascia panels of this heater they must be fitted at the complete conclusion of the installation process. It may be necessary to use the outer fascia to initially locate the heater but then remove it again
so that there is no chance of damage.
Note: Never Ever Rub the Fascia Panels.
Step 1: Replace the glass
Note: If the glass gasket requires 
a replacement, call your nearest Escea agent who will ensure the part is
replaced with the correct type. In the event that the glass is broken by impact, purchase the replacement from an authorised Escea agent only.
Step 2: Hang the outer fascia (larger one) from the lip that extends at the top of the heater at 45 degrees.
If hanging a 4 sided fascia please Refer to sections 25.1 and 25.2 on the next page.
Step 3: Fit the two screws at the base of each side of this fascia. The heater may have to be adjusted in or out of the cavity to ensure the fascia fits correctly.
Step 4: Hang the top edge of the inner fascia (smaller one) from the lip that extends at 45 degrees from the top of the firebox. This fascia is held in at its base by magnets (IB850 & IB600). Alternatively, this fascia is screwed to the fire chassis (IB1100).
Step 5: Place the bottom fascia trim into position. This panel is held on
with magnets. If this panel does not fit, adjust the outer fascia side to side or the heater in/out until the trim fits well.
G8860 _4 Installation Manual NZ
