User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software

dot1x re-authenticate

This command begins the re-authentication sequence on the specified port. This command is only valid if the control mode for the specified port is 'auto'. If the control mode is not 'auto' an error will be returned.

Format

dot1x re-authenticate <slot/port>

Mode

Privileged EXEC

dot1x re-authentication

This command enables re-authentication of the supplicant for the specified port.

Default

Disabled

Format

dot1x re-authentication

Mode

Interface Config

no dot1x re-authentication

This command disables re-authentication of the supplicant for the specified port.

Format

no dot1x re-authentication

Mode

Interface Config

dot1x system-auth-control

This command is used to enable the dot1x authentication support on the switch. By default, the authentication support is disabled. While disabled, the dot1x configuration is retained and can be changed, but is not activated.

Default

Disabled

Format

dot1x system-auth-control

Mode

Global Config

no dot1x system-auth-control

This command is used to disable the dot1x authentication support on the switch.

Format

no dot1x system-auth-control

 

 

Switching Commands

8-99

202-10009-01_060204

Page 165
Image 165
NETGEAR 7300 Series Dot1x re-authenticate, Dot1x re-authentication, Dot1x system-auth-control, No dot1x re-authentication