Clarion TB733W, TB731P, TB732P owner manual Removing the Main Unit

■Fixed Mount (TOYOTA, NISSAN and other ISO/DIN equipped vehicles)

6.

English

This unit is designed for fixed installation in the

2. Secure the mounting brackets to the chassis

REMOVING THE MAIN UNIT

English

Installation and Wire connection manual

dashboard.

If the vehicle is equipped with a factory-installed radio, install the main unit with the parts and screws marked (*) (Figure 8).

If the vehicle is not equipped with a factory- installed radio, obtain an installation kit to install the main unit in the following procedure.

1.Remove the screws at both sides of the main unit and slide the springs to the direction of arrow and remove them (Figure 7).

	as shown in Figure 8. Holes are pre-tapped
	for TOYOTA and NISSAN vehicles;
	modification, such as drilling new holes, of
	the mounting brackets may be required for
	other models.
3.	Wire as shown in Section 7.
4.	Secure the unit in the dashboard, and then
	reassemble the dashboard and the center
	panel.

1.When the rear of the main unit has been secured with the method shown in Figure 6 unfasten the special screw.

2.Remove the outer escutcheon.

3.Insert the hook plate between the spring and the universal mounting bracket, fit tab B of the spring into hole A of the hook plate,

Universal mounting bracket

2–Hook plates

then pull the main unit out by the hook plate. (Insert both the right and left edges of the hook plate.) (Figure 9)

Note:

Keep the hook plate. You cannot remove the main unit without disengaging the hook plate.

Instrument panel

Installation and Wire connection manual

2–Screws

Main Unit

2–Springs

Screwdriver

Figure 7

Dashboard

4–Hexagonal screws * (M5 ⋅ 8)

Mounting bracket ★

(1 pair for the left and right sides)

★

★

Main

Unit

Spring

Outer escutcheon	B
	A
	Figure 9

7. CAUTIONS ON WIRING

★	Main Unit
★
	★	★
Pocket	★	★
		Note 2
Center Panel (Note 1)
*: The parts and screws with this mark
are used to install radio or included in
the installation kit.
★: The parts and screws with this mark	Figure 8
are originally attached to the vehicle.
Note 1: In some cases, the center panel may	Note 2: If a hook on the installation bracket
require some modification (trimming,		interferes with the unit, bend and flatten it
filling, etc.).		with a nipper or a similar tool.

1.Be sure to turn the power off before wiring.

2.Be particularly careful where you route the wires.

Keep them well away from the engine, and exhaust pipe, etc.

Heat may damage the wires.

3.When connecting the ground lead, fasten the ground lead (black) securely to a clean metal plate on the car. (Figure 10)

If the set is insufficiently grounded, it may not operate or there may be noise.

4.If the fuse should blow, check to see if the wiring is correct.

If it is, replace the fuse with a new one with the same amperage rating as the original.

5.To replace the fuse, remove the old fuse of the power supply lead and insert the new one (3A). (Figure 11)

CAUTION

After the connection, fix the lead by a clamp or insulation tape for protection.

Screw on car

Fasten securely to a clean metal plate on the car.

Figure 10

Fuse

Fuse holder

Figure 11

24 TB731P/TB732P/TB733W TB731P/TB732P/TB733W 25