English | Basic Operations | ||
Opening and turning the display | |||
| |||
|
|
| |
|
| WARNING | |
|
| • To prevent the battery from going dead, | |
Owner’s | |||
| operate this unit with the engine running, | ||
|
| ||
|
| if possible. | |
manual |
| • When the liquid crystal panel is operat- | |
| ger caught between the panel and main | ||
|
| ing, be careful not to get your hand or fin- | |
|
| unit or the instrument panel of the car. | |
| |||
|
|
| |
Standing up the liquid crystal panel
1.Press the [OPEN] button and the liquid crys- tal panel comes out and stand up automati- cally.
Adjusting the angel, etc. of the liquid crystal panel
The angle of the liquid crystal panel or protrud- ing amount of the panel from the mounting sur- face can be adjusted depending on the mount- ing angle of the unit or light coming into the car.
●To adjust the angle
1.Every time the [TILT] button is pressed, the liquid crystal panel tilts forward or backward at up to about 20 degrees. The adjusted an- gel is stored in memory.
20˚ | 20˚ |
∗While the liquid crystal panel is opening or closing, the LED of the [FUNC] button blinks.
NOTE:
•If the liquid crystal panel stops in the middle of its operation, press the [OPEN] button to house the panel and press the button again to stand it up.
The unit enters the same display mode as the dis- play was turned off the last time.
NOTE:
• Do not move the liquid crystal panel by hand.
●To adjust the slide position
1.Press and hold the [TILT] button and release when a beep is heard.
The liquid crystal panel slides forward or backward. The adjusted slide position is stored in memory.
*There are 3 adjustable positions available on this panel.
Housing the liquid crystal panel
1.Press the [OPEN] button and the liquid crys- tal panel is housed automatically.
NOTE:
•When leaving this unit unused for a long period of time or leaving your car, be sure to house the liq- uid crystal panel into the main unit.
22 VRX935VD
