Clarion VRX935VD manual 22

22 VRX935VD
English
Owner’s manual
Opening and turning the display
20˚
20˚
Basic Operations
WARNING
•To prevent the battery from going dead,
operate this unit with the engine running,
if possible.
•When the liquid crystal panel is operat-
ing, be careful not to get your hand or fin-
ger caught between the panel and main
unit or the instrument panel of the car.
Standing up the liquid crystal panel
1. Press the [OPEN] button and the liquid crys-
tal panel comes out and stand up automati-
cally.
∗While the liquid crystal panel is opening or
closing, the LED of the [FUNC] button blinks.
NOTE:
•If the liquid crystal panel stops in the middle of its
operation, press the [OPEN] button to house the
panel and press the button again to stand it up.
The unit enters the same display mode as the dis-
play was turned off the last time.
Adjusting the angel, etc. of the
liquid crystal panel
The angle of the liquid crystal panel or protrud-
ing amount of the panel from the mounting sur-
face can be adjusted depending on the mount-
ing angle of the unit or light coming into the car.
●
To adjust the angle
1. Every time the [TILT] button is pressed, the
liquid crystal panel tilts forward or backward
at up to about 20 degrees. The adjusted an-
gel is stored in memory.
NOTE:
•Do not move the liquid crystal panel by hand.
● To adjust the slide position
1. Press and hold the [TILT] button and release
when a beep is heard.
The liquid crystal panel slides forward or
backward. The adjusted slide position is
stored in memory.
*There are 3 adjustable positions available on
this panel.
Housing the liquid crystal panel
1. Press the [OPEN] button and the liquid crys-
tal panel is housed automatically.
NOTE:
•When leaving this unit unused for a long period of
time or leaving your car, be sure to house the liq-
uid crystal panel into the main unit.