Setting the Backgauge
The purpose of this procedure is to ensure that the margin between the leading edge of the copy and the punched holes is correct.
1If your die set is anything other than a GBC Cerlox die set, turn the Backgauge Adjustment Knob clockwise continuously until it stops. If your die set is a GBC Cerlox die set, go to Step 2.
2Check the margin between the leading edge and the punched holes of copies that have been run through the Punch, or, from paper you have run through the Manual Feed Tray. If the margin is correct, go to Starting a Job in this chapter to familiarize yourself with the operation of the FusionPunch II. If the margin is not correct, go to Step 3 to adjust the Backgauge.
Margin
Backgauge
Adjustment Knob
Figure 2-9: Setting the Backgauge Adjustment
General Procedures |