Centering the Punch

The purpose of this procedure is to center the punched hole set on the paper.

1Set up the FusionPunch II in the following modes and destination; "Offline / Punch / Stack 1" (or Stack 2).

2Ensure that the Stacker Tray is in the TOP position. If it is not, press the

RAISE/LOWER STACKER

1 or 2 button either once or twice

until the Stacker moves up to its TOP position. The Punch will not start with the Stacker Tray down.

3Press START .

4

Into the Single Sheet Feeder, feed a sheet of paper of the size required

2

 

for the job.

 

 

 

 

 

5

Press the STOP/RESET

 

 

 

button.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

6Press the RAISE/LOWER STACKER Stacker.

1 or 2 button to lower the

7

8

Open the Stacker Door and remove the punched sheet of paper.

Check the centering of the punched holes, as shown in Figure 2-5.

Punch is centered

Figure 2-5: Checking the Centering of the Punched Holes

Centering the Punch

2-7

Page 49
Image 49
Xerox 16 Series manual Centering the Punch, Press the RAISE/LOWER Stacker Stacker