
5
6
Slide a sheet of tab stock or cover stock partially through the Die.
Ensure that the stock is against the Document Transport Guide Rail, as shown in Figure
Side Guide | Side Guide |
Retaining Screw | |
Infeed Guide | Document |
(Teflon® Plastic | Transport |
Piece) | Guide Rail |
Cover Stock
Figure 2-8: Adjusting the Side Guide
7If punching the 11" edge of the sheet, loosen the Side Guide Retaining Screw. If punching the 8.5" edge of the sheet, add the additional Short Edge Side Guide to the Sheet Eject Strap assembly with the adjustment screws finger tight. Remove the stock and close the Sheet Eject Strap assembly. Now, slide the stock under the Sheet Eject Straps and partially through the Die again.
Note: When using the existing 11" Side Guide, ensure that the Side Guide is under the Infeed Guide (Figure
Teflon® is a registered trademark of E.I. du Pont de Nemours and Company.
General Procedures |