Xerox 16 Series manual Starting a Job, Punching and Stacking

Starting a Job

Punching and Stacking

n

n

n

For punching and stacking the 11" edge in the GBC Stacker without a Bypass installed, follow the procedure below.

For punching and stacking the 11" edge in the Xerox High Capacity Stacker, go to Starting a Job for Bypassing to a Downstream device (Page 2-20.)

For punching and stacking the 8.5" edge, go to Starting a Job for Bypassing to a Dowstream device (Page 2-20.)

To prepare for starting a printing job and sending it to the FusionPunch II, perform the following procedures.

1Set up the FusionPunch II according to the job requirements (For FusionPunch II setup, refer to the Getting Started section, On-line /Off-line).

2From the DocuSP Print Services screen, open the Printer Manager window and click on the Finishing Icon.

Figure 2-10: The Finishing Window

2-14 General Procedures