Xerox 16 Series manual Stacker

Error Message

Possible Cause

Resolution

Please Empty Stacker	1. The Stacker is full.	1. Press the appropriate
	2. The Stacker Tray	Raise/Lower Stacker
	was left in the		button (No. 1 or No.
	DOWN position.
		2) to lower the Stacker
		Tray. Then, unload the
		Stacker.
		2. Press the appropriate
		Raise/Lower Stacker
			button (No. 1 or No.
		2) to raise the Tray to its
		Home position. If the
		problem persists, call your
		GBC or Xerox Service
		Representative.
Please Check	Each time the	Open the Punch Right Door,
Chip Box	FusionPunch II is	and leave it open for at least
	turned ON this	5 seconds before closing it.
	message will appear. It	The total count will not be
	will also appear after	affected by opening the
	100,000 completed	Punch Right Door.
	punches.
Stacker Upper	The Stacker’s Upper	Lower and raise the Stacker
Switch ??	Switch did not release	Tray several times, using the
	during an emptying	appropriate Raise/Lower
	operation.	Stacker		button (No. 1
		or No. 2). Then, press the
		Stop/Reset			button.
		If the problem persists, call
		your GBC or Xerox Service
		Representative.
Figure 3-4: Punch-Generated Error Messages

3-12 Troubleshooting