The different modes and the destination can be changed by pressing the designated Arrow key. As you press each arrow, the following options will appear on the LCD Display Screen:
1.< Change Run Mode
Online - used when sending a job from the host printer. In this mode, the FusionPunch II must be started manually in order to receive paper from the host printer.
(Required when connected to the DT 135.)
Cycle Up - used when sending a job from the host printer. In this mode, the FusionPunch II will start and stop automatically when the host printer starts and stops.
(Not supported in the DT 135.)
Offline - used to start the FusionPunch II without the host printer. In this mode, the FusionPunch II must be started manually before the operator inserts pages in the Single Sheet Feeder.
Online50 - used to deliver offsets in stacks of 50 sets (Complete Books), to the Stackers. In this mode, the operator must start and stop the FusionPunch II manually.
(Required when connected to the DT 135 if offsets of 50 sets are needed.)
Cycle50 - In this mode, the FusionPunch II will start and stop automatically when the host printer starts and stops, as well as deliver offsets in stacks of 50 sets (Complete Books). (Not supported in the DT 135.)
2.^ Change Punch Mode
Punch - the FusionPunch II will punch the long edge of 8.5 x 11 and A4 sized paper.
NoPunch - the FusionPunch II will not punch.
PunchSE - the FusionPunch II will punch the short edge of 8.5 x 11 and A4 sized paper.
Getting Started |
