
Starting a Job
Bypassing to a Downstream device
To prepare for starting a printing job and sending it to the Bypass Destination, as well as the Downstream device, perform the following procedures.
1Set up the FusionPunch II in the Bypass Destination, as well as the correct Punch mode (For FusionPunch II setup, refer to the Getting Started section,
2From the DocuSP Print Services screen, open the Printer Manager window and click on the Finishing Icon.
The Finishing Window will display, defaulted to the Finishing tab, as shown below.
Figure 2-18: The Finishing Window
General Procedures |