Error Messages
From downstream devices
The following is a listing of error messages that could appear on the FusionPunch II Control Panel Display screen genereted by a downstream device. Also included are a description of the possible causes and the resolution for each problem.
Note: These messages will only be displayed when the FusionPunch II is set up in Bypass mode. If all messages are displayed one after the other, make sure that the downstream device is turned on and that the communications cable (DFA Cable) is properly connected.
Error Message | Possible Cause | Resolution |
|
|
|
|
|
|
|
Next Device | The downstream | Check the downstream |
|
|
Not Ready | device from the | device for further |
|
|
| FusionPunch II is not | information. |
|
|
| ready to receive paper. |
|
|
|
|
|
|
|
|
Next Device Faulted | The downstream | Check the downstream |
| 3 |
| device from the | device for further |
| |
| FusionPunch II is in a | information and fault- |
|
|
| Fault condition and is | resolutions. |
|
|
| is not ready to receive |
|
|
|
|
|
|
| |
| paper. |
|
|
|
|
|
|
|
|
Next Device Full | The downstream | Check the downstream |
|
|
| device from the | device for further |
|
|
| FusionPunch II is in a | information. |
|
|
| Full condition and is |
|
|
|
| not ready to receive |
|
|
|
| paper. |
|
|
|
|
|
|
|
|
Figure 3-5: Downstream device - Generated Error Messages
Error Messages |
