Die Pins - the actual cutting tools that are part of the Die Set. Each Die Pin cuts a hole in the paper. A die set that punches several holes has several die pins. Also, these pins are individually removable to adjust for different widths of paper, or for replacement, in case one becomes damaged.
Document Transport Ball Track Assembly - an assembly that is located in the center of the paper path through the Punch. It consists of rails with large plastic ball bearings under which the paper passes with minimal friction. The Document Transport Ball Track Assembly is hinged and can be opened (lifted) in the event of a paper jam. This assembly also contains reflectors for the two sensors installed in that area of the paper path.
DocuPrint - a high speed printer that feeds the actual documents to the FusionPunch II and stackers.
DocuTech - same as DocuPrint above, except it is larger, more configurable, and has a wider range of capabilities.
Edge Guide Adjustment Knob - the knob that is used in centering the Punch to ensure that the holes are centered (side to side) on the paper.
Finishing Device - any device that is installed inline with a printer to process and finish documents. The FusionPunch II is a finishing device. The Stacker is another example of a finishing device.
Infeed Guide - a small, contoured paper guide made of Mylar® or Teflon® plastic and located under the Sheet Eject Strap Assembly, next to the Side Guide.
Mylar® and Teflon® are registered trademarks of E. I. du Pont de Nemours and Company.
Glossary |
