Xerox 16 Series manual Pause/Interrupt, Stop/Reset, Arrows, LCD Display Screen

5Pause/Interrupt

The Pause button is used to stop, or interrupt, a job that is currently running. This may become necessary if a problem occurs or if an adjustment is required.

Note: If running in Cycle Up mode, when you press the Pause/Interrupt

button, the LCD will display: "Delayed Stop."

Press the Start or the Stop/Reset buttons to resume the printer and FusionPunch II.

6Stop/Reset

"LCD DISPLAY SCREEN"

7

8

The Stop/Reset button is used to halt all operation of the FusionPunch II, if it should become necessary. It is also used to reset the machine after an error has been corrected.

Arrows

The arrow controls at the upper right-hand corner of the Control panel are used to scroll the information on the LCD display screen up or down, or, left or right. They are also used to change the different run modes and destinations.

LCD Display Screen

The LCD Display Screen displays the current status of the FusionPunch II, to include operating mode and any error messages that may occur. Also, service personnel use the display to run and interpret diagnostic codes.

1-10 Getting Started