3Open the Right Punch Door.

4Use the Backgauge Adjustment Knob to correct the margin, as shown in Figure 2-9. Adjust as follows:

n To increase the margin between the leading edge of the copy and the punched holes, turn the Backgauge Adjustment Knob counterclockwise.

n To decrease the margin, turn the adjustment knob clockwise.

5Turn the Backgauge Adjustment Knob one click at a time and check the margin at each position. Use the Single Sheet Feeder to run test paper through the Punch. To do this:

a) Set up the FusionPunch II in the following modes and destination;

2

"Offline / Punch / Stack 1" (or Stack 2).

 

b)Ensure that the Stacker Tray is in the TOP position. If it is not,

press the RAISE/LOWER STACKER 1 or 2 button either once or twice until the Stacker moves up to its TOP position. The Punch will not start with the Stacker Tray down.

c)Press START .

d)Into the Single Sheet Feeder, feed a sheet of paper of the size required for the job.

e)Press the STOP/RESET button.

f)Press the RAISE/LOWER STACKER lower the Stacker.

1 or 2 button to

g)Open the Stacker Door and remove the punched sheet of paper.

h)Close the Stacker Door and press the RAISE/LOWER STACKER

1 or 2 button to raise the tray.

6Repeat Steps 4 and 5 until the margin is correct.

Setting the Backgauge

2-13

Page 55
Image 55
Xerox 16 Series manual Offline / Punch / Stack 1 or Stack, Press the RAISE/LOWER Stacker lower the Stacker