To lower the Stacker Tray for unloading, go to the FusionPunch II Control Panel and do the following:

1If in Cycle Up mode:

n and only one stacker is installed, wait for the FusionPunch II and the host printer to cycle down. GBC Fusion Full Stop will be displayed in the LCD Display Screen when the machines have cycled down.

n and the system is equipped with a Second Offset Stacker, you will not have to wait for the the punch and the printer to cycle down. By setting the destination to Stack 1 or Stack 2 the FusionPunch II will automatically switch between the stackers as long as the next stacker’s tray is in the up position.

2

2Press the Raise/Lower Stacker #1 button to lower the tray of the first (#1) Stacker in the system.

Press the Raise/Lower Stacker

#2 button to lower the tray of the

3

4

5

second stacker in the system (if a second Stacker is installed).

Open the Stacker Door and remove the punched copy.

Close the Stacker Door.

Press the Raise/Lower Stacker button(s) to raise the Stacker tray

(or trays) back up to the top position. The Punch will not start with the Stacker tray(s) down. The following applies to Stackers:

n

n

If a single Stacker is used and its tray is down, the Punch Control Panel will display a message telling you to empty the Stacker. The Punch will not start until the tray is up.

If more than one Stacker is employed in the system, at least one of the Stackers’ trays must be up to start the Punch. However, when that Stacker fills up, the Punch will not switch to the other Stacker if its tray is down. Instead, it will stop the Printer and display a message telling you to empty the Stacker.

Using the GBC Stacker

2-27

Page 69
Image 69
Xerox 16 Series manual Press the Raise/Lower Stacker