GETTING STARTED
TABLE/DESK TOP INSTALLATION
CAUTION: Disconnect the telephone line cord before connecting or disconnecting the battery backup in the wall mount bracket.
1.Plug one end of the supplied modular tele- phone line cord into the jack marked TEL located on the back of the telephone base as shown in the diagram.
2.Plug the modular telephone line cord’s other end into a modular phone jack.
3.Insert the supplied AC Adapter’s plug into the jack marked 9V DC 400mA located on the back of the telephone base.
4.Plug the adapter into a standard 120V AC power (electrical) outlet.
5.Align the mounting bracket on the back of the base so that the black rubber feet are towards the bottom of the phone. Insert the bracket’s tabs into the slots and secure the bracket by sliding it upward.
6.Lift the base’s antenna to a vertical position.
7.Set the TONE/PULSE switch located on the back of the base to correct dialing mode. Please check with your local Phone Company if uncertain of the type of service.
8.Place handset in the cradle to begin
initial charging.
WALL MOUNTING INSTALLATION
CAUTION: Disconnect the telephone line cord before connecting or disconnecting the battery backup in the wall mount bracket.
The base unit may be mounted on a standard wall plate.
GETTING STARTED
1.Plug one end of the supplied short modular telephone line cord into the TEL jack located on the back of the base of the phone.
2.Insert the plug of the AC adapter into the jack marked DC 9V 400mA located on the back of the telephone base.
3.Align the mounting bracket on the back of the base so that the black rubber feet are towards the bottom of the phone. Insert the bracket’s tabs into the slots and secure the bracket by sliding it upward.
4.Plug the short modular telephone line cord into the wall plate jack, then align the mounting bracket’s keyhole slots with the wall plate studs and slide the base of the phone down- ward to secure it on the wall.
5.Plug the adapter into a standard AC power (electrical) outlet.
6.Press and lift out the handset holder tab, turn it around so the narrow tab end extends out and slide back into its slot.This will hold the handset in the cradle when the phone is
wall mounted.
7.Lift the base’s antenna to a vertical position.
8.Set the Tone/Pulse switch located on the end of the base to correct dialing mode. Please check with your local Phone Company if uncertain of the type of service.
9.Place handset in the cradle to begin initial charging. Remember, you must charge the phone for at least 12 hours before you use the phone for the first time.
Note: Remember, you must charge the phone for at least 12 hours before you use the phone for the first time.
12 | 13 |
