Telephone Operations
To Replace Battery Backup Batteries:
1.Disconnect telephone line cord and remove desk/wall mount bracket from telephone base
2.Disconnect battery backup connector from the telephone base
3.Remove batteries from desk/wall mount bracket
4.Install four (4) AA Alkaline batteries with negative
5.Connect battery backup connector to ter- minal on bottom of telephone base
6.Install desk/wall mount bracket to telephone base
After installing the four (4) AA Alkaline batteries please refer to the chart below:
Power Supply | Power LED Status |
|
|
AC adapter and good battereies | Steady green |
|
|
AC adapter and no battereies | Steady red |
|
|
AC adapter and bad battereies | Flashing green and red |
|
|
Power failure and good battereies | Slow flashing red |
|
|
Power failure and bad battereies | Fast flashing red |
|
|
Placing a Call
1.Press the TALK button (TALK button will illuminate GREEN) and dial the number you wish to call.
2.To end the call press the TALK button or place the handset in the base.
Or
1.Press the keys of the numbers needed to dial.The LCD will display PREDIAL and the keys pressed.
2.Press the TALK button. Handset will go
Answering a Call
If the handset is out of the cradle, press the TALK button.
If the handset is in the cradle with
If the handset is in the cradle with AutoConnect mode OFF, lift the handset.The handset will be in standby mode. Press TALK button to receive the call.
Refer to BOOST Clarity Power and Volume Control for information on adjusting volume controls on Pages
Last Number Redial:
The last number dialed (up to 32 digits) is stored in the redial memory until another number is dialed.
To use this feature:
1.Press the TALK button.
2.When you hear the dial tone, press the RD/P button.
3.The phone will automatically dial for you.
Pause Feature:
Programming in a pause will cause the phone to wait four (4) seconds before dialing additional numbers.This feature may be used when it is necessary to dial an access code (9, for example) and wait for a second dial tone before you can dial an outside number. Press the RD/P button at the required point during the memory storage process to program a pause.
16
