Getting Started
E
5.Align the mounting bracket on the back of the base so that the black rubber feet are towards the bottom of the phone. Insert the brackets tabs into the slots and secure the bracket by sliding it upward.
6.Lift the bases antenna to a vertical position.
7.Set the TONE/PULSE switch located on the back of the base to correct dialing mode. Please check with your local Phone Company if uncertain of the type of service.
8.Place handset in the cradle to begin initial charging.
WALL MOUNTING INSTRUCTIONS
CAUTION: Disconnect the telephone line cord before connecting or disconnecting the battery backup in the wall mount bracket.
The base unit may be mounted on a standard wall plate.
1.Plug one end of the supplied short modular telephone line cord into the TEL jack located on the back of the base of the phone.
2.Insert the plug of the AC adapter into the jack marked DC 9V 400mA located on the back of the telephone base.
3.Align the mounting bracket on the back of the base so that the black rubber feet are towards the bottom of the phone. Insert the brackets tabs into the slots and secure the bracket by sliding it upward.
4.Plug the short modular telephone line cord into the wall plate jack, then align the mounting brackets keyhole slots with the wall plate studs and slide the base of the phone downward to secure it on the wall.
5.Plug the adapter into a standard AC power (electrical) outlet.
6.Press and lift out the handset holder tab, turn it around so the narrow tab end extends out and slide back into its slot. This will hold the handset in the cradle when the phone is wall mounted.
7.Lift the bases antenna to a vertical position.
8.Set the Tone/Pulse switch located on the end of the base to correct dialing mode. Please check with your local Phone Company if uncertain of the type of service.
9.Place handset in the cradle to begin initial charging. Remember, you must charge the phone for at least 12 hours before you use the phone for the first time.
N G L I S H
9
