SAFETY INSTRUCTIONS
E
N G
The following items are included as part of the
The Load Number of the equipment is 20.
The standard connecting arrangement code for the equipment is CA11A.
NOTICE: The Canadian Department of Communications label identifies certified equipment. This certification means that the equipment meets certain telecommuni- cations network protective operational and safety requirements. The Department does not guarantee that the equipment will operate to the userÕs satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local telecommunications company. The equip- ment must also be installed using an acceptable method of connection. In some cases, the companyÕs inside wiring associ- ated with a single line individual service may be extended by means of a certified connector assembly (telephone extension cord). The customer should be aware that compliance with the above conditions may not prevent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian mainte- nance facility designated by the supplier. Any repairs or alterations made by the user to this equipment, or equipment malfunctions, may give the telecommuni- cations company cause to request the user disconnect the equipment.
Users should ensure for their own protec- tion that the electrical ground connections of the power utility, telephone lines and internal metallic water pipe system, if present, are connected together. This precaution may be particularly important in rural areas.
Caution: Users should not attempt to make such connections themselves, but should contact the appropriate electric inspection authority, or electrician, as appropriate.
The Load Number (LN) assigned to each terminal device denotes the percentage of total load to be connected to a telephone loop which is used by the device to pre- vent overloading. The termination on a loop may consist of any combination of devices subject only to the requirement that the total of the load numbers of all the devices does not exceed 100.
L
I
S
H
SAVE THESE INSTRUCTIONS
5
