Clarity TELEPHONE W1000 manual Operating the Clarity W1000, Neck Loop/Auxilary Port

OPERATING THE CLARITY W1000

➤Neck Loop/Auxilary Port

The W-1000 has a 3.5mm phono jack to use with a neck loop. The volume to the neck loop is controlled with the Clarity Power Control. When the neck loop is plugged in, the receiver in the handset is disabled.

➤Hearing Aid Compatibility

The Clarity W1000 is Hearing Aid Compat- ible with hearing aids that utilize a

T- switch or T-coil.

Once you have installed your Clarity W1000 according to the instructions noted previously, it will be ready to use.

➤To Place or Receive a Call:

1.Adjust the Clarity Power Control to its lowest setting (zero).

2.Pick up the handset and listen for the callerÕs voice or a dial tone. Watch the green sound level light located on the

phone base, next to the program button. It should sign steady.

3.When placing a call, dial as you would any phone and wait for someone to answer.

4.Press the Boost Button

5.Adjust the Clarity Power Control up- wards to a level where the other partyÕs voice is heard loud and clear, and begin conversation.

6.When you complete the call, return the handset to the base unit.

7.After hanging up, the sound level will reset to normal level.

8.Pressing the Boost Button during subsequent conversations will return the volume to your set sound level.

Note: If you made an error while dialing, just depress the hookswitch, listen for a dial tone, and dial again.

16 CLARITY W1000