XLC3.1 REGULATORY COMPLIANCE
XLC3.1 REGULATORY COMPLIANCE
Part 15 of FCC Rules
Information
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Your equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to .
Part 15 of FCC rules.These limits are . designed to provide reasonable protection against harmful interference in residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that . interference will not occur in a particular installation; if this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, you are encouraged to try to correct the interference by one of the following measures:
1.Where it can be done safely, . reorient the receiving television or radio antenna.
2.To the extent possible, relocate the television, radio or other receiver with respect to the . telephone equipment. (This increases . the separation between the telephone equipment and the receiver.)
3.Connect the telephone equipment into an outlet on a circuit different from that to which the television, radio, or other receiver is . connected.
4.Consult the dealer or an experienced Radio/TV Technician for help.
Privacy of communications may not be ensured when using this phone.
WARNING: To maintain the compliance with the FCC’s RF exposure guideline, place the base unit at least 20 cm from nearby persons.
For body worn operation, this handset has been tested and meets the FCC RF exposure guidelines when used with the Clarity and Plantronics accessories supplied or designated for this product. Use of other accessories may not ensure compliance with FCC RF exposure guidlines.
WARNING: Changes or modifications to this equipment not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Industry Canada Technical Specifications
This product meets the applicable Industry Canada technical specifications.
Before installing this equipment, users should ensure that it is permissible . to be connected to the facilities of . the local telecommunications company. The equipment must also be installed
using an acceptable method of connection. In some cases, the company’s inside wiring associated with a single line individual service may be extended by means of a certified connector assembly (telephone extension cord).The customer should be aware that compliance with the above conditions may not prevent degradation of service in some situations. Repairs to certified equipment should be made by an . authorized Canadian maintenance . facility designated by the supplier.
Any repairs or alterations made by the user to this equipment, or equipment malfunctions, may give the telecommunications company cause to request the user to disconnect the equipment.
Users should ensure for their own protection that the electrical ground connections of the power utility, . telephone lines and internal metallic water pipe system, if present, are . connected together.This precaution may be particularly important in .
rural areas.
WARNING: Users should not attempt to make such connections themselves, but should contact the appropriate electrical inspection authority, or electrician, as appropriate.
The Ringer Equivalence Number is an indication of the maximum number of terminals allowed to be connected to a telephone interface.The termination on an interface may consist of any com- bination of devices subject only to the requirement that the sum of the Ringer Equivalence Numbers of all the devices does not exceed five.
(The term “IC:” before the certification/ registration number only signifies
that the Industry Canada technical specifications were met.)
This Class B digital apparatus complies with Canadian
The party responsible for regulatory compliance:
Clarity, a Division of Plantronics, Inc..
4289 Bonny Oaks Drive .
Chattanooga,TN 37406.
Phone:
E
N G L I S H
14 | 15 |
