
How To Operate The Machine
How To Operate The Squeegee
The squeegee wipes the floor while the vacuum motor removes the dirty solution form the floor. Use your right hand to lower or raise the squeegee handle. To operate the squeegee, follow this procedure:
1.To lower the squeegee and start the vac motor, move the squeegee lever to the right and down. See figure 6.
2.To raise the squeegee, lift the squeegee lever up. See figure 7.
NOTE: The center position lets the vac motor con- tinue to run with the squeegee off the floor to avoid drips and also allows you to back up the machine.
How To Fill The Solution Tank
The solution tank lid is at the front. To fill the solution tank follow this procedure:
1.Raise the solution tank lid.
2.Add a cleaning chemical to the solution tank. For the correct amount of chemical, follow the directions shown on the container.
3.Fill the solution tank with water.
4.Lower the solution tank lid.
WARNING: Water solutions or cleaning materi- als used with this type of machine can leave wet areas on the floor surface. These areas can cause a dangerous condition for the operator or other persons. Always put CAUTION signs near the area you are cleaning.
WARNING: Machines can ignite flammable materials and vapors. Do not use with or near flammables such as gasoline, grain dust, solvents and thinners. Only use a cleaning concentrate recommended by the chemical manufacturer.
Figure 6
Figure 7
CLARKE TECHNOLOGY Operator's Manual | Page |