Machine Control Panel
Main Switch (See Figure 1, Item "A")
The main switch turns "ON" the power to the control panel. "O" is "OFF" and "I" is "ON".
Hour Meter (Optional)
The hour meter indicates the number of hours the machine has operated. It runs only when the brush motor is on.
Circuit Breakers (See Figure 1, Items "B" and "C") The circuit breakers reset button are located on the rear cover.
Item B - Brush Motor (10 amp - 115V) (5 amp - 230V)
Item C - Control Breaker (2.5 A)
If a circuit breaker trips, determine which motor is not operating and turn the main switch "OFF". Wait five minutes and push the reset button back in. Turn the main switch "ON" and try again. An authorized service person should be contacted if the breaker trips again.
Control Handles (See Figure 1, Item "D")
The control handles are located at the rear of the machine. They are used to guide the machine.
Solution Control Knob (See Figure 1, Item "E") The solution control knob regulates the flow of chemi- cal solution to the floor. To increase the flow, turn knob clockwise. To decrease the flow, turn counter clockwise.
Vacuum Motor Switch (See Figure 1, Item "F") To activate vacuum motor, lower squeegee handle. Handle has two positions. Lowest position is operat- ing position and the middle position is transport to clear vacuum hose.
Brush Motor Switch (See Figure 1, Item "G")
To activate brush motor, lower handle. Brush Motor and solution flow will activate when the traverse buttons are pushed. To shut brush motor off, raise handle to top position.
DD
E A
BC
FG
Figure 1
Page | CLARKE TECHNOLOGY Operator's Manual |
