HOW TO CORRECT PROBLEMS IN THE MACHINE
PROBLEM | CAUSE | ACTION |
|
|
|
There is no solution flow. | The solution valve is closed. | Open the solution valve. |
| There is an obstruction in the solution hose | Remove the obstruction from the hose and the |
| or filter. | filter. |
| The solution valve or electric wiring is | Repair or replace the valve and the electric |
| damaged. | wiring. |
| The solution tank is empty. | Fill the solution tank. |
| The solution module is damaged. | Check solution module |
|
|
|
The solution flow does not stop. | The solution valve is open or dirty. | Close or Clean the solution valve. |
| The solution valve or wiring is damaged. | Repair or replace the valve and the wiring. |
| The solution valve is dirty | Clean the solution valve. |
| There is a damaged seat and washer in the | Replace the seat and washer. |
| solution valve. |
|
| The solution module is damaged. | Check solution module. |
|
|
|
The machine does not remove all the | The squeegee is up | Lower the squeegee. |
water from the floor. |
|
|
| The squeegee tilt is not correct. | (See Figure 11, page 23) |
| The vacuum tank is full. | Drain the tank. |
| The screen filter is dirty. | Clean the screen filter. |
| There is an obstruction or damage in the | Remove the obstruction or repair the damage. |
| squeegee, squeegee hose or standpipe. |
|
| The vacuum motor is not running. | Check for tripped breaker. Have an autho- |
|
| rized service person make repairs. |
| The squeegee hose is disconnected, or | Check and connect hose. |
| damaged |
|
| The squeegee blade is damaged, worn, or | Turn or replace the squeegee blade. |
| incorrectly installed. | Correctly install the squeegee blade. |
| The squeegee pressure is not correctly | Adjust the pressure of the squeegee. |
| adjusted. |
|
| The gaskets on the cover of the recovery | Replace the gaskets. |
| tank are damaged. |
|
| The recovery tank lid is on wrong. | Rotate lid 180° and replace. |
|
|
|
Page | CLARKE TECHNOLOGY Operator's Manual |
