Wall Mount Use
1.Slide the handset hanger tab out and reverse its position (rotate it 180 degrees). Slide it back into place so that the hook points up (See diagram #4). This will keep the handset from falling out of the cradle when it is mounted on the wall.
2.Insert the Wall Plate adapter (See diagram #5). It snaps into place. The cords phone line should run underneath the
3.With the Wall Plate adapter installed, plug the 8in short phone cord into the telephone jack on the CSC40 and then into the jack on the wall.
4.Holding the phone slightly above the mounting screws on the wall jack, push the phone against the mounting screws so they are hooked into upper and lower key- hole slots on the back of the phone. Slowly slide the phone down until it snaps into place (See diagram #6).
5.Connect the handset coil cord (curly cord) to the handset and to the telephone.
6.Lift the handset and listen for a dial tone. If you hear a dial tone, your phone is ready to use. If there is no dial tone, check all your cords to make sure they are plugged in securely.
DIAGRAM #4 – Reversing the hook | DIAGRAM #5 |
|
DIAGRAM #6 – Wall installation
PROGRAMMING MEMORY DIAL BUTTONS
Your CSC40 Phone holds 12 programmed Memory Dial Buttons.
To program your
1.Lift the handset.
2.Press the PROG button (See diagram #7).
3.Press one of the 12 Memory Dial buttons (M1 - M12) located on top of the phone (See diagram #8). Each button can be programmed (or reprogrammed using the same procedure) for a phone number up to 21 digits long.
4.Using the keypad, dial the number you would like to save, including 1 and the area code (if applicable). (See diagram #9).
5.Press the PROG button again (See diagram #7).
6.To register your stored phone numbers, use the erasable phonebook card located on the top of your phone. IMPORTANT: The phonebook card is
8
