ClearSounds CSC500 manual Desk / Table Mounting, Wall Mounting

Desk / Table Mounting

1.Connect one end of the 6 ft telephone cord to the line jack on the back of the phone and connect the other end to a modular phone jack.

2.Connect one end of the coiled handset cord to the handset and the other end to the phone base.

3.Lift the handset and listen for the dial tone. If you don’t hear a dial tone, re-check all the installation steps.

Wall Mounting

Desk tab	Wall mount
position	tab position

1.Slide the handset hanger tab out and reverse its position (rotate it 180 degrees). Slide it back into place so that the hook points up. This will keep the handset from falling out of the cradle when it is mounted on the wall.

2.Plug the 6-inch short phone cord into the telephone jack on the phone, run the phone cord underneath the wall plate adapter and through the opening. The excess telephone line can be positioned into the recessed area on the bottom of the mounting plate.

3.Insert the wall plate adapter by holding the wall plate adapter so that the raised mounting pins line up with the phone’s keyholes on the back. Once the holes are lined up, push the wall plate adapter in towards the phone and then slide the plate upwards until it is securely seated on the phone

4.With the wall plate adapter installed, plug the 6-inch short phone cord into the jack on the wall.

8 – ENGLISH