Clevo M665SE manual Disassembly, Memory Removal Sequence

5.Gently push the two release latches ( 10 & 11 ) on the sides of the memory socket in the direction indicated by the arrows (Figure c).

6.The RAM module(s) 12 will pop-up (Figure d), and you can then remove it.

c. d.

Disassembly

Figure 5

Memory Removal

Sequence

c. Push	the	release
latch(es).

d. Remove the module(s).

1011

1011

12

2.Disassembly

7.Push the latches to release the second module if necessary.

8.Insert a new module holding it at about a 30° angle and fit the connectors firmly into the memory slot.

9.The module will only fit one way as defined by its pin alignment. Make sure the module is seated as far into the slot as it will go. DO NOT FORCE IT; it should fit without much pressure.

10.Press the module down towards the mainboard until the slot levers click into place to secure the module.

11.Replace the bay cover and the screws (see page 2 - 8).

12.Restart the computer to allow the BIOS to register the new memory configuration as it starts up.



12 RAM Module(s)

Removing the System Memory (RAM) 2 - 9