E. Glass Assembly
WARNING
Handle glass doors with care.
• Inspect the gasket to ensure it is undamaged.
• Inspect the glass for cracks, chips or scratches.
•Do NOT strike, slam or scratch glass.
•Do NOT operate appliance with glass door removed, cracked, broken or scratched.
•Replace glass door assembly as a complete appliance.
CAUTION
Avoid damaging light bulb or glass.
•Use cotton gloves or rag to handle bulb. (Oil film on bulb, including skins oils, will cause premature failure of bulb.)
•Pull out the tray that houses the light bulb (see Figure 12.11).
Removing Glass Assembly
Pull the two glass assembly latches out of the groove on the glass frame. Remove glass door from the appliance (see Figure 12.10).
Replacing Glass Assembly
Replace the glass door on the appli- ance. Slide the top of glass into slot at top. Pull out and latch the two glass latches into the groove on the glass frame.
BRACKET
WITH SLOT
GLASS
ASSEMBLY
TRAY |
Figure 12.11 |
•Remove old light bulb and replace it with a new bulb (see Figure 12.12). Recommended replacement: Sylvania Candelabra 75 watts.
LIGHT BULB |
Figure 12.10 Glass Assembly
F. Replacing Light Bulb
WARNING
HOT! DO NOT TOUCH.
SEVERE BURNS MAY RESULT. CLOTHING IGNITION MAY RESULT.
•Glass and other surfaces are hot during operation and cool down.
•Do NOT change bulb when appliance is hot.
Figure 12.12 Light Bulb Location |
•Put tray back in original location, making sure that the tray engages the clip inside the light box and that it is flush with the box.
Heat & Glo • Crescent II • | 37 |