Heat & Glo LifeStyle CRESCENT II B. Vent Components Diagrams continued, Dvp-Trap, DVP-TRAP1

B. Vent Components Diagrams (continued)

Note: Heat shields MUST overlap by a minimum of 1-1/2 in. (38 mm). The heat shield is designed to be used on a wall 4 in. to 7-1/4 in. (102 mm to 184 mm) thick. If wall thickness is less than 4 in. (102 mm) the existing heat shields must be field trimmed. If wall thickness is greater than 7-1/4 in. (184 mm) a DVP-HSM-B will be required.

8in.

(203 mm)

Heat

Shield

15-1/8 in.

(384 mm)

					Term Cap	Minimum	Maximum
						Effective Length	Effective Length
					Trap1	3-1/8 in.	4-5/8 in.
		12 in.		Max		79 mm	117 mm
	(305 mm)		Effective			5-3/8 in.	9-3/8 in.
			Length		Trap2
	DVP-TRAP					137 mm	238 mm
Horizontal Termination Cap

Wall Shield Firestop	DVP-TRAP1	Wall Shield Firestop	HSM	DVP-TRAP2
Heat Shield			Heat Shield

DVP-TRAP1	DVP-TRAP2
Horizontal Termination Cap Kit	Horizontal Termination Cap Kit
	(Shown with optional extended heat shield)

	Wall Shield Firestop	DVP-TRAP1	Wall Shield Firestop		DVP-TRAP2
DVP90ST	Heat Shield		DVP90ST	HSM
				Heat Shield

DVP-TRAPK1	DVP-TRAPK2
Horizontal Termination Cap Kit	Horizontal Termination Cap Kit
Figure 16.3 DVP vent components

Heat & Glo • Crescent II • 2083-902 Rev. N • 7/09 47