Heat & Glo LifeStyle CRESCENT II Finishing, A. Mantel Projections, B. Facing Requirements

11 Finishing

A. Mantel Projections

Figure 11.1 shows the minimum vertical and corresponding maxi- mum horizontal dimensions of appliance mantels or other com- bustible projections above the top front edge of the appliance.

Outside Fit Surround

The outside fit surround design is used for facing materials less than 3/4 inch for combustibles, and less than one inch for non-combustibles. The surround is designed to fit flush on finishing materials. Heat & Glo recommends using our cabinets or 1/2 inch finishing materials (see Figure 11.3).

Note: All measurements in inches.

AIR

SPACE

16-1/4 IN.

6-5/16 IN.

CEILING

COMBUSTIBLE

SHEATHING

HEADER BOARD

12
11
10
9				27 IN.
8
7
6
5			13-3/4 IN.
4
3
2		7-3/4 IN.
1
	2-3/4 IN.

FROM BOTTOM OF HOOD (VISIBLE WITH DOOR REMOVED)

1 in.

Adjust fireplace position if facing material is other than 1/2 inch thick.

CAUTION

For Outside Fit Surrounds

•Surface temperatures are hot around fireplace opening.

•Finishes may discolor or peel if not suited to temperatures above 200º F.

Figure 11.1 Clearances to mantels or other combustibles above appliance

Top View

½ Inch

MANTEL

LEG

Figure 11.2 Mantel leg or Wall projections (Acceptable on both sides of opening.)

B. Facing Requirements

There are two options to finish the front facing on the fireplace, outside fit surround and inside fit surround.

To cut the arch use the dimensions shown in Figure 11.4.

30-7/16 IN.

22-7/8 IN.

Figure 11.4 Outside Facing Dimensions

32 Heat & Glo • Crescent II • 2083-902 Rev. N • 7/09