Heat & Glo LifeStyle CRESCENT II Log Set Assembly LOGS-CrescentII, D. Positioning the Logs

D. Positioning the Logs

Log Set Assembly: LOGS-Crescent II

CAUTION: Logs are fragile.

Figure 12.1

RUBBER	REMOVE
BANDS	PACKING

Figure 12.2

STEP 1: Remove the rubber band from the log set and the packing around the log. Check to see if the back lighting / ember bed bulb works. See Replacing Light Bulb (Section 12.F) in manual if bulb needs to be replaced.

Figure 12.3 Logs not shown in picture

STEP 2: LOG REPLACEMENT ONLY: Remove old log set from fireplace by removing one screw from the pilot. Remove old logs and burner. Slide the new log set over the orifice and make sure the orifice engages into the burner neck. Also, make sure the pinched end of the burner tube fits in the V- shaped slot in the bracket. Then, install one screw through the pilot and log set, then through the bracket.

Figure 12.5

STEP 3: Place log (SRV2083-181) on right side of burner between burner and firebox, and tip the log so it rests on the burner tube.

LOCATION OF

CLEAR ROCK

Figure 12.6

STEP 4: Place clear rock on top of orange film in front of log set. It is recommended using the clear rock which is no bigger than one inch.

2083-903B

Heat & Glo • Crescent II • 2083-902 Rev. N • 7/09 35