Murray 11052x4NC manual Assembly

ASSEMBLY

11.Remove the shut-off switch, switch bracket, screw, and wire harness from the parts bag.

12.Mount the throttle control and shut-off switch to the right handle. Secure the eyelet, the shut-off switch, the switch bracket and the throttle control to the handle with the screw as shown in Figure 6.

13.Connect the terminal to the shut-off switch (see Figure 6).

14.Connect the other end of the wire as- sembly to the two wires at the rear of the engine (see Figure 7).

NOTE: If the shut-off switch wires are not properly connected, the shut-off switch will not stop the engine.

15.Attach the throttle control cable and the wire assembly to the upper and lower handle with the tie strap (see Figure 8). Thread the pointed end of the tie strap through the other (square) end of the strap. Pull the tie strap tight around the throttle cable and the lower handle.

NOTE: One side of the tie strap is rough, the other side is smooth. The rough side must be on the inside of the loop formed when the ends of the tie strap are put together.

16.Try to loosen the tie strap. If it will loos- en, it is put together with the smooth side to the inside of the loop. Remove the tie strap and reverse the direction.

17.Cut off the excess strap.

Screw Eyelet

Shut-off

Switch

Terminal

Switch

Bracket

Throttle

Control

Figure 6

Wire Assembly

Figure 7

Tie Strap

Figure 8

F–041306C 9