Quick Evaluation
Before Installation
Introduction
To Check Your Inverter’s Performance Before Installation:
Installation
Requirements
Installation
Installation Requirements
•
On/Off Switch to Off
Connect Terminals
Connect Power Source
On/Off Switch to On
Connect Test Load
1.Turn the inverter Off (see page 11 for details). If the power source is a DC power supply, switch it Off as well.
2.Connect cables to Power Input Terminals (see page 7 for details).
3.Connect cables to power source (see page 7 for details).
4.Check to make sure all connections are secure.
5.Turn the inverter On. If the power source is a DC power supply, switch it On first.
6.Plug in the test load.
The inverter should supply power to the load. If the inverter is not working properly, refer to the Troubleshooting Guide on page 14 or Power and Protection Indicators section on page 12.
The inverter must be installed in an area that meets all of the following requirements:
A.Dry
Do not place in an area where water can drip or splash on the inverter.
B.Cool
Ambient air temperature should be between 30°F and 105°F (0°C and 40°C). The cooler the better.
C.Ventilate
Allow at least 1 inch (3 cm) of clearance around the inverter for proper airflow. Make sure that ventilation openings on the ends of the unit are not obstructed.
D.Safe
Do not install the inverter in the same compartment as a battery or in any compartment that contains flammable liquids such as gasoline.
E.Close to Battery
Install unit as close to battery as possible (without being in the same compartment) to minimize the length of cable required to connect the inverter to the battery. It is better and cheaper to run longer AC wires than longer DC wires (cables).
CAUTION To avoid fire, do not cover or obstruct ventilation openings. Do not install inverter in a zero- clearance compartment. Overheating may result.
CAUTION The inverter must only be connected to batteries with a nominal output voltage of 12 volts. It will not work with a 6 volt battery, and will be damaged if it is connected to a 16 volt battery.
WARNING This unit contains components which can produce arcs or sparks. To prevent fire or explosion, do not install in compartments containing a battery or flammable materials, or in a location which requires ignition protected equipment.
4 English | Nothing comes close to a Cobra™ 5 |
