Mode Functions | Cobra Electronics LI 6500WXC guide

Mode Functions

Operation

During privacy code scan (while receiving an incoming transmission), you can choose from the following:

a. Press and hold the Talk button to communicate on that channel/privacy code. Your radio will remain on that channel/privacy code and return to Standby mode.

b. Press the Channel Up or Channel Down button to resume scanning privacy codes.

If you press the Talk button while scanning, but more than

10 seconds after receiving a transmission, you will transmit on the channel/privacy code on which you last received a transmission. This will then return the radio to Standby mode.

If you do not press any button within 10 seconds, your radio will automatically resume scanning privacy codes.

During privacy code scan (while not receiving a transmission), you can choose from the following:

a. Press and hold the Talk button to communicate on the channel/privacy code that was displayed before you entered mode functions or the channel/privacy code on which, during scanning, you last received a transmission. This will return the radio to Standby mode.

b. Press the Mode button to proceed to set memory location scan (see page 21 for further details).

c. Press the Lock/Enter button to return to Standby mode on the channel/privacy code that was displayed before you entered mode functions or the channel/ privacy code on which, during scanning, you last received a transmission.

20

Image 24

Cobra Electronics LI 6500WXC owner manual Mode Functions

Contents

LI 6500WXC Making Life Easier and Safer Product Features Features Privacy Codes Replace battery compartment cover and belt clip Caring for Your microTALK RadioEstimated operation time on full charge 12 hours Using Your Radio Insert radios into desktop charger as shown Operation Channels Or Channel Down buttonListening for a Response Call Button Press and release the HiLow button To Illuminate DisplaySeconds Lock Feature To turn the lock feature on or offAuto Squelch/Maximum Range For less than five seconds Signal Strength Meter To attach a speaker/microphoneTo connect a wall charger/adapter MicroTALK Range Mode Functions Scrolling through Mode FunctionsSet Keystroke Tones On/Off Privacy Codes Set Ctcss Privacy Codes To select a Ctcss privacy codeAfter selecting a channel, press To proceed to step Set DCS Privacy Codes To select a DCS privacy codeSmall numbers flash on the display Through NOAA* All Hazards Radio Channels To listen to All Hazards Radio channels To turn VOX mode on or off Voice Activated Transmit VOXTo set VOX sensitivity Memory Locations To program a memory locationPress the Lock/Enter button to enter Press the Lock/Enter button Press the Mode button to Choose one of the following To recall a stored memory channel location DisplayWhile recalling a stored memory location To de-program a memory location Flash on the displayWhile de-programming a memory location Channel Scan Your microTALK radio can automatically scan channelsTo scan channels Press the Mode button to proceed to set privacy If you press the Talk button while scanning, but more than Privacy Code Scan To scan privacy codes Mode Functions Memory Location Scan To scan memory locations Press the Mode button to proceed to other functions To change call settings VibrAlert and Call AlertIs displayed Call Tone Settings To change a call tone settingPress the Mode button until Roger Beep Confirmation Tone Keystroke Tones To change keystroke tones General Specifications and FCC License General Specifications Important Notice FCC License Required Product Service Product Service Safety and Trademark Acknowledgement Safety Information for microTALK Radios Warranty Limited One-Year Warranty on Radios & Charger