VibrAlert and Call Alert | Cobra Electronics LI 6500WXC specification


	Introduction	Operation	Customer Assistance	Warranty

VibrAlert and Call Alert

•

Your microTALK radio can alert you to incoming signals by sounding an audible call tone, by vibrating silently or both.

Mode Button

Channel Buttons

To change call settings:

1.Press the Mode button until the Call Setting icon flashes on the display. The current setting (“01” vibrate + ring, “02” vibrate only or “03” ring only)

is displayed.

2.Press the Channel Up or Channel Down button to change the call setting.

3.Choose one of the following:

VibrAlert + Ring

VibrAlert Only

Ring Only

a. Press the Mode button to enter the new setting and proceed to other functions.

b. Press the Lock/Enter button to enter the new setting and return to Standby mode.

23

Image 27

Cobra Electronics LI 6500WXC owner manual VibrAlert and Call Alert, To change call settings, Is displayed

Contents

LI 6500WXC Making Life Easier and Safer Product Features Privacy Codes Features Replace battery compartment cover and belt clip Caring for Your microTALK RadioEstimated operation time on full charge 12 hours Insert radios into desktop charger as shown Using Your Radio Operation Call Button ChannelsOr Channel Down button Listening for a Response Press and release the HiLow button To Illuminate DisplaySeconds For less than five seconds Lock FeatureTo turn the lock feature on or off Auto Squelch/Maximum Range MicroTALK Range Signal Strength MeterTo attach a speaker/microphone To connect a wall charger/adapter Privacy Codes Mode FunctionsScrolling through Mode Functions Set Keystroke Tones On/Off To proceed to step Set Ctcss Privacy CodesTo select a Ctcss privacy code After selecting a channel, press Through Set DCS Privacy CodesTo select a DCS privacy code Small numbers flash on the display To listen to All Hazards Radio channels NOAA* All Hazards Radio Channels To turn VOX mode on or off Voice Activated Transmit VOXTo set VOX sensitivity Press the Lock/Enter button Memory LocationsTo program a memory location Press the Lock/Enter button to enter Choose one of the following Press the Mode button to To recall a stored memory channel location DisplayWhile recalling a stored memory location To de-program a memory location Flash on the displayWhile de-programming a memory location Channel Scan Your microTALK radio can automatically scan channelsTo scan channels If you press the Talk button while scanning, but more than Press the Mode button to proceed to set privacy To scan privacy codes Privacy Code Scan Mode Functions To scan memory locations Memory Location Scan Press the Mode button to proceed to other functions To change call settings VibrAlert and Call AlertIs displayed Roger Beep Confirmation Tone Call Tone SettingsTo change a call tone setting Press the Mode button until To change keystroke tones Keystroke Tones General Specifications General Specifications and FCC License Important Notice FCC License Required Product Service Product Service Safety Information for microTALK Radios Safety and Trademark Acknowledgement Limited One-Year Warranty on Radios & Charger Warranty