Installation And
Microphone/Speaker Bracket
Mounting And Powering The Radio
Microphone/Speaker Bracket
To Install The Microphone/Speaker Bracket:
1.Install the microphone/speaker bracket on a vertical surface near the transceiver using the supplied stainless steel screws.
Installation And
Warning Sticker
Mounting And Powering The Radio
Warning Sticker
FCC regulations require that the Warning Sticker supplied with this radio be applied to a spot where it is easily seen by the radio operator. Be sure the location is clean and dry before applying the sticker.
Use Supplied Template
See page 75 for template.
Insert Transceiver
Flush Mount
A Flush Mounting kit is included with your CobraMarine™ VHF radio to allow its installation in almost any flat surface.
To Mount The Transceiver Flush In Almost Any Flat Surface:
1.Use the supplied template to mark and cut an opening in the flat surface. See page 75 for template.
CAUTION
Before cutting, be sure the area behind the flat surface is clear of any instruments or wires that might be damaged in the process.
Power Connection Cables
– +
Red Cable
Positive (+)
Black Cable
Negative
Electrical Power Connection
Your CobraMarine™ VHF radio is powered from the vessel’s 13.8 volt negative ground direct current electrical system (12 volt nominal). A fused power connection lead is provided at the back of the transceiver.
To Connect To A Power Source:
1.Attach the black power wire to a negative ground.
2.Attach the fused red power wire to the positive side of the power system.
Attach Mounting Brackets
Adjust Screws
2.Insert the transceiver into the opening.
3.Attach the mounting brackets to the sides of the transceiver with the adjusting screw flanges facing the back of the flat surface.
4.Tighten the adjusting screws against the back of the flat surface until the flange on the front of the transceiver is tight against the flat surface.
CAUTION
A reverse polarity connection will damage the radio.
|
|
|
|
28 English | Nothing comes close to a Cobra® 29 | ||
