External Devices
And Connections
Installation And
External Devices And Connections
•
Your CobraMarine™ VHF radio is set up to connect auxiliary devices for navigation, convenience, and added versatility. As is the case with the antenna, choosing these devices is best done with the advice and guidance of a knowledgeable dealer.
Standard connectors are provided on the front and back of the transceiver.
External Devices
And Connections
Installation And
Global Positioning System (GPS) Device (Not Included)
Cobra® strongly recommends that you obtain and connect a GPS device to your CobraMarine™ VHF radio. By having a GPS connected, your position will be continuously indicated on the LCD and, most importantly, it will be included automatically in any DSC distress message you may need to send. That will take the “search” out of “search and rescue.”
Microphone/Speaker Cord Connection Socket
External Speaker and PA Jack
External Speaker and PA Jack
Microphone/Speaker Attachment
Connect the Microphone/Speaker to the cord socket located at the left side of the front of the transceiver.
To Connect The Microphone/Speaker Attachment:
1.Align the connector and push it firmly into the socket.
2.Tighten the captive nut to hold the connector in place.
3.Slide the waterproof sleeve over the nut until it seats in the recess around the socket.
External Speaker (Not Included)
An External Speaker can provide greater volume to hear messages than the speaker incorporated in the CobraMarine™ microphone/speaker.
To Install An External Speaker:
1.Connect the speaker lead to the standard jack on the back of the transceiver.
Public Address Speaker (Hailer) (Not Included)
At times, it may be handy to hail other boats or give instructions to line handlers on the dock. Your CobraMarine™ VHF radio can be switched to operate in the Public Address mode through an attached PA speaker.
To Install A Public Address Speaker:
1.Connect the PA speaker lead to the standard jack on the back of the transceiver.
GPS Connection | To Install A GPS Device: |
1.Install the GPS device in a convenient location according to its manufacturer’s directions.
2. Bond the NMEA out negative wire to the black wire of the GPS interface cable.
3.Bond the NMEA out positive wire to the red wire of the GPS interface cable.
NOTE
When bonding the wires, make sure connections are secure and properly insulated.
4.Connect the new combination cable to the GPS device and to the back of the transceiver.
NOTE
Satellite acquisition time is dependent on the
GPS device.
|
|
|
|
32 English | Nothing comes close to a Cobra® 33 | ||
