Operating Your Radio

MEM Icon

GMRS

R VHF

T X

A

B U I C

ATIS VOX LOMEDHISAMEMEM

Advanced Operation

To Recall a Stored Memory Location:

1.Press the MEM/ESC button. The MEM icon will be turned On.

2.Press the Channel Up/Down button to select the memory location. If a memory location has been programmed, its associated channel will display on the LCD. Your radio is now in Marine Standby mode on the selected memory location.

To Exit Memory Location Mode:

Press the MEM/ESC button to return the radio to Marine Standby mode. The last channel used in Marine Standby mode will now be displayed on the LCD and the MEM icon will disappear.

To Erase Stored Memory Locations:

1.Press and hold the MEM/ESC button for two (2) seconds. The memory location number will be displayed on the matrix and the MEM icon will be turned On.

2.Use the Channel Up/Down button to advance to the memory location you want to erase.

3.Press the MEM/ESC button to select the memory location.

4.Use the Channel Up/Down button to change to the channel to read “00” at the selected memory location.

5.Press the MEM/ESC button to erase that channel.

Repeat steps 2 through 5 to erase as many additional memories as you want.

6.Press and hold the MEM/ESC button for two (2) seconds. This will return the radio to Memory mode.

7.Press and release the MEM/ESC button again to return to Marine Standby mode.

Operating Your Radio

SCAN Button

MEM

ESC

SCAN Icon

R

GMRS

VHF

T X

 

A

B U I C

ATIS VOX LOMEDHISAMEMEM

Channel Up/Down Buttons

FLOATING MARINE HH350

CALL

ENTSETUP

Advanced Operation

Channel Scan Mode

During Channel Scan mode, the radio will rapidly switch from channel to channel through all the channels.

NOTE

The radio must be squelched for Channel Scan mode to function. See page 18 for Squelch procedure.

To Enter Channel Scan:

1.From Marine Standby mode, press the SCAN button. The radio will immediately begin to scan the entire channel map selected in the active channel map. CHANNEL SCAN will display on the matrix.

2.A signal on any channel will stop the scan for 10 seconds to allow you to listen to the traffic on that location. After 10 seconds, the radio will resume scanning.

3.Press the Channel Up/Down button to resume scanning before the 10-second pause has completed or to change the scan direction.

4.To EXIT Channel Scan mode, press the SCAN button again. The SCAN icon will disappear from the LCD and the radio will return to Marine Standby mode.

30 English

Nothing Comes Close to a Cobra® 31

Page 18
Image 18
Cobra Electronics MRHH350FLT Channel Scan Mode, To Recall a Stored Memory Location, To Exit Memory Location Mode