Cobra Electronics MRHH350FLT owner manual Install/Remove Antenna, Wrist Strap and Belt Clip

Installation	Install/Remove Antenna
Install/Remove Antenna		•
Antenna	1. To install the antenna turn the antenna into the radio
	clockwise to tighten. Do not overtighten
	2. To remove the antenna turn the antenna counterclockwise.
	This radio transmitter IC: 906A-MRHH350 has been
	approved by Industry Canada to operate with the supplied
	antenna. Other antennas are strictly prohibited for use with
	this device.
	Cet émetteur radio IC: 906A-MRHH350 a été approuvé par
	Industrie Canada pour fonctionner avec l'antenne fournie.
	D'autres antennes sont strictement interdits pour une
	utilisation avec cet appareil.
Batteries and Charger		•

Wrist Strap and Belt Clip

Installation

Wrist Strap and Belt Clip

•

Belt Clip Belt Clip

Use the spring-loaded belt clip to carry the radio on your person.

1.Slide the belt clip into the guide channel on the back of the radio until it is locked in place.

2. To attach the wrist strap, insert it through the hole at the top of the belt clip, feed it through the looped end and pull tight to secure to the belt clip.

Insert Belt Clip onto Radio

3.Press open the belt clip, slide it over the belt and release

the clip.

4. To remove the belt clip from the radio press the tab on the belt clip, which unlocks the clip, and slide it out.

LiON Battery Pack

Install Battery Pack

The radio is shipped with a sealed lithium-ion (LiON) battery pack (P/N CM 110-025) that is rechargeable.

WARNING

The charger provided for this radio is only to be used to charge the battery pack provided. Do not charge any other type of batteries in the charger as fire, explosion or battery damage will occur. Avoiding extreme room temperatures will also help prolong the life of the battery pack for the radio.

Wrist Strap Attachment

When your rechargeable batteries begin to discharge too quickly, it is time to install a new battery pack. Your radio will also operate with five (5) high-quality AA alkaline batteries, using the optional alkaline battery tray.

Installing the Battery Pack

1.Position the battery pack over the back of the radio.

Tighten Screw	2. Engage the battery pack into the radio by sliding to the top
	until battery pack is fully seated against radio housing.

3.Tighten the screw using the end of the belt clip to secure

the battery pack to the radio. Do not overtighten. Only use the end of the belt clip to tighten the screw.

8English

Secure Radio

	GMRS
	VHF
	A
	B U I C
ATIS VOX LOMEDHISAMEMEM
	CALL
TW	16/9
	MEM
	ESC
SCAN

Nothing Comes Close to a Cobra® 9