Cobra Electronics MRHH350FLT owner manual Memory Location Mode

Operating Your Radio

Advanced Operation

Advanced Operation

Operating Your Radio

TRI-WATCH Button

TW

EN

Using Tri-Watch

Tri-Watch Scan Mode:

1.	From Marine Standby mode, press the TRI-WATCH
	button. The TW SCAN will display on the matrix
	along with the three marine channels stored in the
	Tri-Watch memory.
2.	The radio will scan through the three (3) Tri-Watch
	memory channels.

MEM/ESCENTButtonSETUP

MEM

ESC

CAN	HML
Memory Location Number

Memory Location Mode

Your radio has unlimited memory locations for storing your most frequently used channels. These memory locations can be selected individually or can be scanned. (See page 32 under Memory Location Scan.)

To enter Memory mode, press MEM/ESC button. The display will show the MEM icon and the Memory Channel bank will be displayed on the matrix.

Tri-Watch Scan Mode

GMRS

R VHF

T X

A

B U I C

ATIS VOX LOMEDHISAMEMEM

3. A signal on any one (1) of the three (3) channels will

stop the scan for 10 seconds to allow you to listen to

the traffic on that location.

NOTE

After the Tri-Watchscan stops to monitor a channel, as long as you do not press any buttons within 10 seconds, your radio will automatically resume scanning the Tri-Watchchannels.

4.Press the Channel Up/Down button to resume scanning the Tri-Watchchannels or to change the scan direction.

5.To EXIT the Tri-Watchscan, press the TRI-WATCHbutton again. The TRI icon will disappear from the LCD and the radio will return to Marine Standby mode.

	R	GMRS
		VHF
	T X
	A
	B U I C
ATIS VOX LOMEDHISAMEMEM
Channel Up/Down Buttons
FLOATING	MARINE HH350

CALL

ENTSETUP

Channel Number

GMRS

R VHF

T X

A

B U I C

ATIS VOX LOMEDHISAMEMEM

To Program Memory Locations:

1.Press and hold the MEM/ESC button for two (2) seconds. The memory location number will be displayed on the matrix and the MEM icon will be turned On.

2.Use the Channel Up/Down button to advance to the memory location (00-99) you want to program.

3.Press the MEM/ESC button to select the memory location.

4.Use the Channel Up/Down button to change to the channel you want to store into the selected memory location.

5.Press the MEM/ESC button to program that channel. The memory location will be displayed on the matrix again.

Repeat steps 2 through 5 to program as many additional memories as you want.

6.Press and hold the MEM/ESC button for two (2) seconds. This will return the radio to Memory mode.

7.Press and release the MEM/ESC button again to return to Marine Standby mode.

28 English Nothing Comes Close to a Cobra® 29