Battery Low

Operation

Insert Radio(s)

Using Your Radio

For charging microTALK® radio(s) in desktop charger:

1.Insert radio(s) into desktop charger as shown.

2.Insert round connector of 120 volt adapter into jack on back of charger.

3.Plug 120 volt adapter into electrical outlet.

Introduction

On/Off Power

 

 

 

Operation

Customer Assistance

Warranty

Turning on Your microTALK® Radio To turn on your radio:

1.

Rotate the On/Off Volume knob clockwise

 

to turn on your radio.

2.

Rotate the On/Off/Volume knob clockwise to

 

increase the volume or counterclockwise to

If charging light is not on, check position of radio. Radio should be upright. The charge indicator light will stay on as long as the radio is in the charging well, even after the batteries are fully charged.

It normally takes about 15 hours to fully recharge batteries. Batteries will not be damaged if they stay in the charging well longer than that.

Each port can charge one radio. Uses 120 Volt adapter. Use only Cobra NiMH batteries, model GA-BN with charger model GA-CD.

Cobra recommends your radio is turned off while being charged.

The Basics to Get You Started

Your microTALK® radio is easy to use.

Battery Low

reduce the volume.

Your microTALK® radio is now in Standby mode, ready to receive transmissions. The radio is always in Standby mode, except when the Talk, Call or Lock/Mode buttons are pressed.

Your microTALK® radio has a battery level meter that shows when battery power is decreasing. The greater the number of bars visible, the stronger the battery level. When the battery level is low, the last bar and “bALo” will flash indicating your batteries should be replaced or, if using rechargeable batteries, recharged.

To get started, simply:

1.Rotate the On/Off Volume knob to turn on your radio.

2.Press the Channel Up or Channel Down button to select a channel.

Both radios must be tuned to the same channel/privacy code to communicate.

3.Press and hold the Talk button while speaking into the microphone.

4.When finished talking, release the Talk button and listen for a response.

2 English

Battery Save Mode

 

Auto Battery Save

 

 

Your microTALK® radio has a unique circuit

 

 

 

 

 

designed to extend battery life. If there are

 

 

 

no transmissions for 10 seconds, the radio will

 

 

 

automatically switch to Battery Save mode and

 

 

 

the Power Saver icon will flash in the display.

 

 

 

This will not affect the radio’s ability to receive

 

 

 

incoming transmissions.

 

Nothing Comes Close to a Cobra® 3

Page 5
Image 5
Cobra Electronics PR5000DX Using Your Radio, For charging microTALK radios in desktop charger, Auto Battery Save