Installation
Your Detector
Installation
•
Where To Mount Your Unit
You will get optimum performance from your detector if you Mount it at a point approximately in the center of the vehicle, as low as possible on the front windshield without obstructing the unit’s view of the road either to the front or rear. You can also mount it directly on the dashboard.
Windshield Mounting | Dashboard Mounting |
|
|
The unit’s lens must not be blocked and the LaserEye should have a clear view out the back window to allow 360° detection.
The LaserEye Should Have A Clear View
Radar and laser signals pass through glass but not through other materials and objects. Objects that can block or weaken incoming signals include:
■Windshield wiper blades
■Mirrored sun screens
■Dark tinting at the top of the windshield
■Heated windshields currently available on some vehicles (Instaclear for Ford, Electriclear for GM). Consult your dealer to see if you have this option.
2English
Installation
Your Detector
Windshield Mounting
1.Attach the rubber
cups to the bracket.
2.Make sure the rubber cups and your windshield are clean.
3.Push the bracket firmly
onto the windshield.
4.Attach the detector to the bracket. Check the angle of the unit.
5.To adjust the angle if necessary, gently push or
pull on the bracket to bend it. DO NOT use the detector to bend the bracket.
6.Plug the power cord into the detector.
7. Plug the cigarette lighter adapter on the power cord into your vehicle’s cigarette lighter.
8.You can temporarily remove the detector whenever you wish by depressing the bracket release button and sliding it off the bracket.
Nothing comes close to a Cobra® 3
