Cobra Electronics XRS 9600 Getting Started, System Ready, Tone Visual Display

Installation

Your Detector

Dashboard Mounting

1.Place the detector on the dashboard to find a location where the unit has a clear, level view of the road.

The angle CANNOT be adjusted after mounting.

2. Remove the paper backing from one (1) side of the hook-and-loop fastener.

3. Attach the pad to the

Getting Started

Your Detector

Getting Started

•

On-Off/ Volume Control Rotate clockwise (away from you)

To Turn On The Unit And Adjust The Audio Volume

dashboard at your chosen location and remove the other paper backing.

4.Attach the detector to the hook-and-loop fastener. You can remove and reattach the unit as often as you like.

Rotate the On-Off/ Volume control clockwise (away from you).

Tone	Visual Display
Three (3) beeps	Testing
	System Ready
	The display will then cycle
	through the user mode settings
	(city or highway, Intellimute
	and SmartPower status).

Start-up is complete when the display continuously shows the current compass direction (N, NE, E, SE, S, SW, W or NW) plus single letters indicating current user mode settings (c = City mode, City X Beep Off mode and City X+K mode, h = Highway mode, i = IntelliMute on).

6.Plug the power cord into the detector.

7. Plug the cigarette lighter adapter on the power cord into your vehicle’s cigarette lighter.

4English

Power On	Start-Up Complete
Testing	NW	h

System Ready

NOTE

In some vehicles, power is supplied to the cigarette lighter even while the ignition is off. If this is the case with your vehicle and you have turned the SmartPower off, you should turn off or unplug your detector when parking for lengthy periods. Cobra recommends leaving SmartPower at the factory setting, which is on.

Nothing comes close to a Cobra® 5