Coleman 5177 manual To Light, English-3

■Remove lantern parts from package.

Igniter Electrode	Lantern Frame
Reflector
	Base

■Note: Use Coleman 16.4 oz. disposable propane cylinders. The LP-gas cylinder(s) used with lanterns must be constructed and marked in accordance with the specifications for LP-gas cylinders of the U.S. Department of Transportation or Transport Canada, CAN/CSA B339.

Ventilator-Globe-Bail	Ball	Mantles
Assembly	Nut

■ Always use genuine Coleman® #21 size

mantles. If using Insta-Clip® II tabbed mantles,

follow the instructions on the mantle package.

■ If using tie style mantles, tie mantles around

■Take lantern outdoors away from

ignition sources.

■Turn fuel valve off. (Fig. 7)

Fig. 7

■Remove protective cap from top of propane cylinder. Save cap for use in storing. (Fig. 8)

Fig. 8

grooves in burner. (Fig. 1)

■ Distribute folds on mantle evenly. Cut off surplus

string 1/4" (0.6cm) from knot. (Fig. 2)

■ For INSTASTART™ electronic ignition lanterns,

be careful that mantle does not snag

on electrode.

DANGER

• EXPLOSION - FIRE HAZARD

Fig. 1

Fig. 2

• Propane is heavier than air and can accumu-

late in low places. If you smell gas, leave the

area immediately.

• Always attach or detach propane source out-

doors; never while lantern is lighted, near

flame, pilot lights, other ignition sources or

while lantern is hot to touch.

• Always light & use lantern outdoors.

• This lantern must not be exposed to flamma-

■Light bottom of mantle evenly. Burn until nothing but white ash remains. Once the mantle has been burned, it is very fragile. Be careful not to touch it with finger or match. (Fig. 3, 4)

ble vapors or liquids during lighting.

• This lantern is red hot during use and can

ignite flammables too close to the mantles.

Keep flammables at least 12 inches from the

Fig. 3

Fig. 4

sides and 48 inches from the top of the

lantern. Keep gasoline and other flammable

liquids and vapors well away from lantern.

■ Always extend base before use. (Fig. 9)

■ Complete assembly. (Fig. 5, 6)

Fig. 5

Fig. 6

■ Screw propane cylin-

der into lantern. Take

■Set lantern into base. (Fig. 11)

To Light

WARNING

If you smell gas:

1.Do not attempt to light appliance.

2.Extinguish any open flame.

3.Disconnect from fuel supply.

4.Call 1-800-835-3278.

WARNING

•Replace any mantle with a hole in it. A hole can cause lantern to overheat and create a hazard. Never operate lantern without heat shield.

care not to cross-thread.

Hand tighten only.

(Fig. 10)

Fig. 10

Fig. 11

English-3