Coleman 5177 manual To Turn Off, English-4

Fig. 17

.2"

(5 mm)

■Assemble reflector to back of lantern. Position the reflector clips onto the center of the two back rails and slide either

upward into the reflecting position or downward into the storage position. (Fig. 12)

Fig. 12

NOTE: If lantern does not light, repeat above step. If the lantern does not light after several attempts,

check for a spark while clicking the igniter. If no

spark is present, check the electrode gap. The gap should be about .2" (5 mm). Carefully bend electrode to set gap. If the

lantern is wet due to rain, high humidity, etc., the electrode may not spark. Use lighting procedure for match light version lanterns. (Fig. 17)

■Reflecting position. Bottom tab rests inside lantern frame. (Fig. 13)

■Storage position. Reflector hangs from back rails. (Fig. 14)

■Brightness may be adjusted with fuel valve. (Fig. 18)

Fig. 18

To Turn Off

■Turn fuel valve off. (Fig. 19)

CAUTION

•SERVICE SAFETY

•Keep all connections and fittings clean. Inspect propane cylinder and lantern propane connections for damage before attaching.

•During set up, check all connections and fittings for leaks using soapy water. Bubbles indicate a leak. Never use a flame.

To Store

■ Make sure lantern

is cool.

Match Light

Lantern

■Push lighted match through lighting hole, hold near mantle and open fuel valve fully. (Fig. 15)

Fig. 15

INSTASTART™

Electronic

Ignition Lantern

■Open burner valve and repeatedly push igniter button and ignite the mantles. (Fig. 16)

Fig.16

■ Move lantern away
from flame (including
pilot lights) and other
ignition sources.
■ Remove propane
cylinder from lantern.
(Fig. 20)
■ Replace protective
cap on propane
cylinder.	Fig. 20
■ Lantern can
be placed in
base for secure
storage. (Fig. 21)
	Fig. 21

DANGER

WARNING

•BURN HAZARD

•Never leave lantern unattended when hot or in use.

•Keep out of reach of children.

•EXPLOSION - FIRE HAZARD

•Never store propane near high heat, open flames, pilot lights, direct sunlight, other igni- tion sources or where temperatures exceed 120 degrees F (49°C).

•The cylinder must be disconnected when the lantern is in storage.

English-4