Removal Of Infant Car Seat From Base:
Pull car seat release handle and lift car seat from base (fig. a).
Attaching Infant Car Seat To Base:
Verifythat there are no objects on top of base or between base
and infant car seat that will prevent proper latching of car seat.
- Verify lower anchor belt is routed or stored properly.
With child facing the rear of the vehicle, lower car seat into
base and push down on car seat to lock car seat into base
(fig. b).
Testto be sure car seat is locked in base. Lift on car seat
at top of seat back (fig. c) and at child’s feet .
Attachment Of Infant Car Seat To Base:
(fig. a)
1Car Seat
Release
Handle
(fig. b) (fig. c)
1
2
3
19
1
2
12
1 2
1
2
Carry handle should be kept in the carry position (see “Carry Handle Operation”
section).
Adjust recline using recline indicator on the side of car seat. Line on recline
indicator MUST be in green striped zone (fig. d).
If line is not in green striped zone, adjust base using the recline foot (see
“BaseAdjustment” section), and recheck recline of car seat. Repeat until
recline indicator is in green striped zone.
If base can not be adjusted to locate the line in the green
striped zone:
1. Try a different seating position.
2. Do not use this infant car seat.
NOTE: Vehiclemust be parked on flat, level surface during this installation.
Verifythat LATCH belt or vehicle seat belt is still tightly adjusted around base.
(fig. d)
20
4
5
Recline
Indicator
Green
Striped
Zone
6
Line