Section 8 - Installing the Car Seat Base with LATCH | 27 |
Check that the base is securely held.
If the base moves easily more than 1" (25mm) to either side, try another position, or do not use the car seat in the vehicle.
When installing the base, ensure the bottom of the base is in contact with the vehicle seat.
NOTE: See additional information on page 33 about putting extra support under the front of the base.
Section 8 - Installing the Car Seat Base with LATCH | 28 |
FITTING THE CAR SEAT INTO THE BASE.
Before putting the car seat into the base make sure there are no objects on or in the base.
Connect the car seat to the base.
"CLICK"
NOTE: listen for a "CLICK" when the car seat is installed into the base, and lift the car seat to ensure the car seat is fully conected to the base.
To remove the carseat from the base, pull firmly upwards on the release lever at the rear of the car seat, and lift the carseat upwards.
WARNING: DO NOT use the car seat if it is not securely connected to the base.