Compaq 400 486 DX2/40 MHZ 250 MB 4 MB 9.5, 400C 486 DX2/40 MHZ 250 MB 4 MB 9.5, 400CX 486 DX2/40 MHZ 250 MB 4 MB 8.4, 410 486 DX2/50 MHZ 250 MB 4 MB 9.5, 410C 486 DX2/50 MHZ 250 MB 4 MB 9.5, 410C 486 DX2/50 MHZ 350 MB 4 MB 9.5, 410CX 486 DX2/50 MHZ 350 MB 4 MB 8.4, 420C 486 DX4/75 MHZ 350 MB 4 MB 10.4, 420C 486 DX4/75 MHZ 420 MB 8 MB 10.4, 420CX 486 DX4/75 MHZ 420 MB 8 MB 10.4, 430C 486 DX4/100 MHZ 420 MB 8 MB 10.4, 430C 486 DX4/100 MHZ 720 MB 8 MB 10.4, 430CX 486 DX4/100 MHZ 720 MB 8 MB 10.4 Chapter 3.21 Display Assembly Components (Models 400 and 410)

1.Peel off the top layer of one of the anti-skid pads to expose the adhesive.

2.With the adhesive-side down, place the anti-skid pad into the raised oval outline on the CPU base and the battery tray (Figure 3-77).

Chapter 3.21 Display Assembly Components (Models 400 and 410)

This section contains removal and replacement procedures for the following display assembly components:

o Bezel

o Latches

o Inverter board

Removing and Replacing the Display Bezel

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> WARNING <<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<

Ensure that the power cord is disconnected from the electrical outlet and that the battery pack is removed from the computer before beginning replacement procedures. Failure to disconnect power could result in